How do you clear an Onan fault code?
How do I reset the code on my Onan generator?
- Locate the primer button on the generator.
- Hold the primer button down for at least 30 seconds.
- Release the button and start the generator.
- Allow the generator to run for 15 minutes, to ensure that the code has cleared.
What does it mean when my Onan generator blinks 3 times?
Should your Onan generator light blink 3 times in a row, it shows a service shutdown, and you will require secondary Onan generator troubleshooting codes from your generator. Press the Prime button once to prompt a second, two-digit fault code.
When does the Onan generator send out an error code?
That may be a bad pun, but it is the truth when it comes to Onan generators. When something goes wrong, the generator will send out a code to tell you the problem. If you blink, you may miss the number of the error code. How to Read Onan Generator Fault Codes: It’s not hard to read the Onan Fault Code blink system, once you get used to it.
What does code 12 over voltage on Onan mean?
Code 12 – Over Voltage This problem comes from a faulty inverter and that part is overcharging the generator. The only way to solve this Fault Code problem is to take the generator to a qualified Onan dealer or repair shop. Alternative sources for this code may be a lack of fuel or a clogged filter problem.
Why is my Onan generator not producing enough spark?
Second, you can also take the fuel line off the fuel pump and see if enough fuel is getting through to the engine. A third issue may be the armature coil. If the generator is not getting enough spark, then the armature coil may be going bad and not producing the spark you need to run your generator.
Where is the armature coil on an Onan generator?
One way to make sure it is the armature coil is if your generator needs time to cool down before starting up again. Usually, you may not be able to re-start the unit until 30 minutes have passed by. The armature coil is normally located next to the flywheel making it not to difficult to find and replace.
That may be a bad pun, but it is the truth when it comes to Onan generators. When something goes wrong, the generator will send out a code to tell you the problem. If you blink, you may miss the number of the error code. How to Read Onan Generator Fault Codes: It’s not hard to read the Onan Fault Code blink system, once you get used to it.
Code 12 – Over Voltage This problem comes from a faulty inverter and that part is overcharging the generator. The only way to solve this Fault Code problem is to take the generator to a qualified Onan dealer or repair shop. Alternative sources for this code may be a lack of fuel or a clogged filter problem.
What do I need to start my Onan generator?
Getting the Engine Running Before any evaluation of the controls, regulator or generator can proceed, the Onan engine must have oil and fuel, be in running condition and the 12-volt battery charged. The electronic governor, 151-0752, on Models BGM and NHM, Spec B and later, must be functioning properly.
Second, you can also take the fuel line off the fuel pump and see if enough fuel is getting through to the engine. A third issue may be the armature coil. If the generator is not getting enough spark, then the armature coil may be going bad and not producing the spark you need to run your generator.
