How do you level a fireplace insert?

After inserting your electric fireplace into position place a level on the top of the insert. Keep one corner of the level on the insert and tilt the level up to bring the bubble to the center. The side that you’ve lifted up is the side that needs to be shimmed.

How do you adjust the shutter on a gas fireplace?

Adjust the Air shutter if the Air to Fuel mixture is not correct:

  1. Flame is Yellow or orange producing soot ( low air leading to a rich flame) – Introduce more air by turning clockwise.
  2. Flame is very blue (too much air) – Reduce the air by turning counter clockwise.

Can I adjust my gas fireplace?

To adjust the flame height on your appliance open the control panel and locate your main gas valve. If the valve has a dial marked “High-Low”, rotating the dial will adjust your flame height.

What is a fireplace air shutter?

An air shutter is a metal collar that regulates how much oxygen is mixed with the gas flowing to your burner. It is a very needed tool because fireplaces rely on air for combustion to operate.

Where to place the baffle plates on a fireplace?

PLACE ALL 4 BAFFLE PLATES ABOVE AIR TUBES BOTH SIDES CLOSEST TO THE FIRE BOX WALL AS SHOWN ( 2 LEFT AND 2 RIGHT) 3. PLACE BAFFLE PLATES AS FAR BACK AS POSSIBLE, 212 MM FROM FRONT TO BACK.

What should I do if my gas fireplace wont start?

If you can not see a spark when pushing the ignitor, first clean the metal surfaces of the thermopile, thermocouple, igniter, and and pilot. A light sanding with sandpaper, wire brush, or steel wool works great to remove the soot.

What are the minimum clearances for a gas fireplace?

MINIMUM CLEARANCES: COMBUSTIBLE WALL GYPROCK HEBEL 75 STEEL FRAME FIBRE CEMENT SHEETING COMBUSTIBLE WALL 513 50 725* (REFER TO CLAUSE, PAGE 5) FIBRE CEMENT SHEETING STEEL FRAME STEEL FRAME STEEL FRAME STEEL FRAME MINIMUM CLEARANCES FOR THE CELESTIAL 900 SOLID FUEL APPLIANCE INSTALLED WITH METAL FRAMING AND DEFAULT FLUE KIT

What’s the best way to install a firebox?

1.OPEN THE DOOR TO ABOUT 70 DEGREES TO THE FRONT OF THE FIREBOX. LIFT THE DOOR UPWARDS UNTIL THE DOOR CLEARS THE HINGES AND MOVE IT OUT OF THE WAY. 2. THREAD ONE SCREW AND ONE WASHER (SUPPLIED) TO EVERY NUT SERT SHOWN. MAKE SURE THE WASHER IS AS CLOSE TO THE SCREW HEAD AS POSSIBLE.

Can a masonry fireplace be converted to a gas insert?

Transform your existing masonry or zero clearance fireplace into a beautiful, efficient heat source with one of our direct vent gas fireplace inserts, featuring award-winning designs and innovations.

Which is the best brand of fireplace inserts?

Fireplace Xtrordinair® offers extraordinary models of premium traditional or contemporary wood or gas burning fireplaces and fireplace inserts, with dozens of beautiful designer faces and fireback combinations to personalize your fireplace.

If you can not see a spark when pushing the ignitor, first clean the metal surfaces of the thermopile, thermocouple, igniter, and and pilot. A light sanding with sandpaper, wire brush, or steel wool works great to remove the soot.

What does a restrictor do on a fireplace?

MountainStoveGuy Minister of Fire 2. the restrictor prevents flue gas to leave the cmbustion chamber, with that you prevent heat to leave the combustion chamber. The more heat you prevent from leaving the combustion chamber the more heat comes out of the unit.