Where are the slide controllers on a coach?

Different coach but my slide controllers are behind a panel that holds my cable/sat input in one of the bays. I have electric motors also that look identical to yours. Mine are Kwikee but like stated all owned by Lippert now. On my motors there is a 3/4 inch nut and also on the motor is a “lock” switch.

Why does my slide not retract after new motor?

After the new motor was installed, the slide still would not retract. The “square rods” connected to the motor were detached to assure the new motor was functioning. We found that power to the motor existed only when the “out” part of the slide’s in/out button was pushed. There was no power to the motor when the “in” side of the button was pushed.

Is there an electrical problem with the slide out?

Finding an apparent electrical button, the control panel was removed and the wires for the stuck slide were placed on another slide “in/out” button. Again, there was no power to the stuck slide when the “In” was pushed. The two young mobile repair techs were now perplexed and did not have the skill to trouble-shoot the electrical issue.

Why is my slide out not working on my car?

To get back home to Katy, the power supply wires to the motor were “reversed” so the slide could be retracted so I could drive home to Katy, TX. With the power supply wires “reversed”, the slide will now not extend.

How are the leveling jacks and slide out issues?

When I turn the hydraulic system on I can clearly hear the electric over hydraulic systems engaging, when I set the system to auto level the coach I see all four jacks extend until they each contact the ground however there is insufficient force to lift the coach or to complete a thorough leveling cycle.

Why are my slide out jacks not working?

Perhaps there is a screen that is clogged. With all the valves and solenoids and wiring it may be possible that one is not operating correctly or perhaps not at all. If there is hydraulic schematic available I could isolate the hydraulic flow of main pressure to the components.

How much pressure do you need for a slide out?

Alpine used HWH systems for both leveling jacks and on most coaches, for slide operation as well ( electric slide mechanism was used on some bedroom slides as well as some generator slides) With You being familiar with hydraulic operation, the common operating pressure for the jack and slide systems is 3000 lbs. when working properly.

Why are there two solenoids for slide out jacks?

A second solenoid for each Jack is unnecessary because the retraction of each Jack is accomplished by the two return springs located on each Jack. that being said,,, the room slide out and generator slide out are both extended and retracted under pressure. There is a separate solenoid for both directions.

Is the Lippert slide out controller a problem?

A final update for my slide-out problem. The good folks at RV Masters in Houston diagnosed the problem to be a “bad” Lippert Slide-Out Controller. The “in/out” switch and relay all work fine and were not the problem. A new controller was installed and the slide out is working great again!

Where can I buy a slide out RV controller?

RV Masters charged $130 for the new controller and $140 for an hour of labor to install the controller. A new Lippert Slide-Out Controller can be purchased from Amazon for $85 (not including shipping) –> .

Where is the power cable on a Kwikee step?

Follow the black wire bundle from the connector to the black box mounted to the step. That’s the Step Controller. You’ll find several colored wires going into the controller. There should also be a power cable from the controller to the step motor. Refer to the Lippert manuals for your specific Kwikee step model for the correct wiring.

What causes an RV slide out to not work?

A faulty motor or gearbox could be the problem if your RV slide-out gear system is motor-driven. In such cases, if the motor is faulty or breaks down, then the mechanism will not work. If the motor-driven gearbox system is faulty, for whatever reason, your RV slide-out will not work. Your RV slide may experience resistance as it moves in and out.

What happens when your slide out won’t slide out?

A stubborn slide-out, though, can turn your trip in to a disaster. Either you spend your days climbing over furniture in an attempt to live in an RV with the walls pushed in or you can’t depart for home with a slide-out that refuses to retract for road travel.

Why does my coachmen slide out not work?

KevinS121 Some college 952 satisfied customers 2007 crossroads cruiser ct32. Rear slideout won’t engage. 2007 crossroads cruiser ct32. Rear slideout won’t engage. There is 12v at the motor, when switch engages it drops to zero.

What are the common problems with fifth wheel slide outs?

Each slide-out operating system has its own unique problems. Check out the following common problems with slide-outs on a fifth wheel. A faulty motor or gearbox could be the problem if your RV slide-out gear system is motor-driven. In such cases, if the motor is faulty or breaks down, then the mechanism will not work.

Do you need to manually operate an RV slide out?

You may need to resort to manually operating your slide out, so it is best to become familiar with the process before an issue comes up. RV slide-outs do have a maximum extension and retraction, so going beyond these parameters could cause damage to the system.

Why is my passenger side slide not retracting?

My trip to Baton Rouge for LSU football this past weekend went to heck when my passenger side slide would not retract (we stayed Thursday night in Lake Charles, LA to visit my son’s family). After calling a couple of Lake Charles RV repair shops, the initial thought was the slide motor had quit working.

Are there any warranties on a coachman?

Warranty information with respect to these items is available from your dealer. The Warrantor further makes no warranty with regard to any product used for commercial purposes, as a permanent residence or as a rental unit, or any product not registered and normally used in the United States or Canada. LIMITATION AND DISCLAIMER OF WARRANTIES

Where is the slide out controller on a motorhome?

For my motorhome, there are two slide out controllers attached to the “roof” of the middle basement compartment between the two main beams of the frame. One controller for the passenger side slide-out and one for the drive side slide-out. RV Masters charged $130 for the new controller and $140 for an hour of labor to install the controller.

Are there two relays for the slideroom motor?

Missing a circuit to supply power to slideroom motor.The drawing pictures one relay to power the in and out voltage to the motor- there are 2 power relays.

What kind of equipment does a 1998 Winnebago have?

(**) In addition to previously listed equipment, these models also include range, three burner with oven, rear view monitor system and automatic hydraulic leveling jacks (#) These models include generator, water heater and roof air (N/A on Rialta models)

When did the first Winnebago car come out?

First appearing in 1960, Winnebago has grown to be an icon in the recreational vehicle industry. From the beginning, Winnebago pursued high attention to quality building furniture and components specific to their recreational vehicles.

When is the best time to order Winnebago parts?

If you do not see the product you are looking for — or if you have any questions, need help identifying your motorhome and/or parts, or would rather speak with someone before you place an order, please give us a call. Our team is available 8-5 PM Monday through Friday to assist you with your Winnebago parts needs.

Where can I buy Winnebago parts for my RV?

And don’t forget to check out our eBay store for great savings on a variety of different Winnebago parts! … … … … … … … …

Missing a circuit to supply power to slideroom motor.The drawing pictures one relay to power the in and out voltage to the motor- there are 2 power relays.

What are the colors of the slide out switch?

It makes sense that there is a relay somewhere as the wires on the back of the slide out control switches are different colors (orange “slide in” wire, blue “slide out” wire, and a common purple wire for all three switches). Somewhere the orange and purple wires at the control switch change to green and yellow wires at motor.

Why is my Lippert slide out on my RV not working?

If you’re having trouble getting the Lippert slide room on your RV to budge, there are a few different things you should do in order to inspect the system and find a solution.

What happens when you push the slide out button on an RV?

If your RV or motorhome doesn’t have the juice, your slide outs aren’t going to budge! If you push your slide-out button and nothing happens, double check to make sure that the path of the slide out is unobstructed.

How does a Lippert slide out motor work?

It depends on what you are trying to adjust but those slide out systems have adjustments underneath at the arms to make all adjustments. The end bracket will have horizontal bolts that need loosened and then a vertical bolt that can turn to move a corner up or down.

What does it mean when your Slide Room is not working?

This is an indication that there’s an obstruction in the hydraulic system. To help you figure out next steps after you determine the problem lies in the hydraulic system, RV expert Dave Solberg walks you through a quick inspection of the underside of the slide room.

Are there any problems with the slide out on an RV?

Troubleshooting RV Slide Out Problems: One main problem with slide outs is that they may get out of alignment. The good news here is that each slide can be adjusted separately. All you have to do to fix it is take your RV to a dealer and let them make an adjustment.

Are there any problems with the slide out?

Most slide out problems are not that difficult to trace and then solve. There will be those that require the help of a professional technician to repair. The key would be to get to know your system and learn when the task is beyond your abilities to handle .

What to do if your coachmen won’t slide out?

Coachmen slideout won’t slide out, Coachmen slideout won’t slide out… Coachmen slideout won’t slide out, how can I fix this? In a camp ground champion, pa. Show More Show Less Ask Your Own RV Question Share this conversation Answered in 5 days by: 10/16/2014 RV Mechanic: Robert, RV Mechanic replied 6 years ago Robert, RV Mechanic Category: RV

What does no power mean on a circuit breaker?

No power at the connection terminal while the circuit breaker is in the On position indicates a defective circuit breaker. Remove the receptacle cover from the outlet without power. Check for voltage at the wire connection terminals on the side of the receptacle. Verify the voltage is correct.

What should I do if I lose power to a circuit?

Wear safety glasses and turn off anything that will make you feel safer getting them out if they are “fused” on there from too much heat. Perhaps turning off the main breaker would be a good idea!

Can a flipped circuit breaker cause a power shutdown?

Going through this process can save you a ton of time later on if you discover the problem was there all along. Once you’re sure the problem isn’t a flipped circuit breaker, start the hunt for every GFCI outlet in your home. Even if the outlet is on the other side of the house, it can be the reason for your power shutdown.

Why are the outlets on my coach not working?

The 120-volt outlets in your coach are wired to the distribution center and protected with a circuit breaker and isolated from the 12-volt system as well. Can’t say I tried that. Do you have a specific idea as to the cause?

Can a neutral conductor give you a shock if the breaker is not working?

That is why you can have a situation where the breaker is supplying power to the circuit, but the outlet (receptacle, light, appliance, etc.) is not working. This is the situation where a neutral conductor can give you a shock!

What should I do if there is no power to an outlet?

These outlets save time when installing an outlet but sometimes the wires can come loose. These type of outlets are called back stab or stab-in outlets. If you have these type of outlets then you can check to see if possibly a wire has popped out. Turn off the breaker to the outlet before doing any type of electrical troubleshooting.

Why are all my dead outlets on the same circuit?

Then check your whole house for GFCI outlets. Maybe one has tripped somewhere and is on the same circuit as your dead outlets. Sometimes houses are wired strangely and outlets on opposite sides of the house are placed on the same circuit. If you can rule out a GFCI tripping, then you might have to begin testing each outlet.

Where are the slide controllers on a coach?